Step by Step Oil Painting Instructions By Dan Schultz

Step 1: Prepare to Paint

For this 18″ x 24″ studio painting I used Claessens double-oil-primed linen canvas, #15 (my usual painting surface), mounted on 1/2″ Gator Board. I applied an initial wash to the canvas with a color that I hoped would end up being pretty close to my final color for the creek bed in the foreground. I don’t use any medium with my paint, just mineral spirits (Gamsol made by Gamblin) that I sometimes use to thin the paint (which I did for the initial wash, then lightly wiped it with a paper towel). I also laid out all my palette colors (listed below).

Brushes:

Holbein Killington bristle flats and Utrecht bristle flats, sizes 2 - 12

Royal Langnickel sable flats (series 5590), sizes 2 - 12

Assorted palette knives for painting, mixing paint and cleaning my palette

Paint:

(Starting from the bottom left on my palette and working upwards and to the right.)

Titanium White (Utrecht)

Cadmium Lemon (Winsor & Newton)

Cadmium Yellow (M. Graham & Co.)

Cadmium Yellow Deep (Utrecht)

Yellow Ochre (Winsor & Newton)

Cadmium Red (M. Graham & Co.)

Venetian Red (Gamblin)

Permanent Alizarin Crimson (Gamblin)

Transparent Oxide Red (Rembrandt)

Viridian (Gamblin)

Cobalt Blue (Winsor & Newton)

Ultramarine Deep (Rembrandt)

Ivory Black (M. Graham & Co.)

The last pile is a gray mixture made from mixing the leftover paint on my palette from my last painting.

Step 2: Draw the Scene on the Canvas

Using a #4 Holbein Killington bristle flat brush, I used some of the gray mixture on my palette to draw my scene. (It really doesn’t matter much what color is used for the drawing since it will eventually be covered up anyway. I usually just try to use a color that isn’t too intense and that is dark enough in value for me to see it over the initial wash.) I thinned the paint with some mineral spirits so that it would flow off my brush easily and tried to keep the drawing simple and accurate.

My next step was to determine the color and value of my darker foreground shadows and to mix it right next to the color I used for the drawing step. I had already decided that I wanted those shadows to be lighter than I had painted them in the plein air painting, so I compared the shadows between the two paintings to make sure I was on the right track. I used a #6 Utrecht bristle flat brush for these block-in steps while being careful to keep my paint consistency just thick enough to cover each area. (I apply thicker paint in certain areas later in the process.)

I then continued to the shapes next to the shadows and blocked them in with the approximate values and colors of each shape. (Notice that I continue to mix the colors on my palette right next to (touching) the other colors. This allows me to squint and compare the values right on my palette, then I can double-check value and color accuracy once I block in the shapes on the canvas.) Throughout this process, I did a lot of squinting at my palette mixtures, my source painting and at the larger painting to compare the value relationships between shapes.

Next, I continued by blocking in the mountain areas while trying to keep them simple. I wanted to get the majority of the canvas covered with the most accurate values and colors I could before I got into much detail. (It gets easier to accurately compare values and colors as more of the canvas gets covered.) Notice that I continued to work outward from my initial block-in areas to the areas next to them.

Please visit this link to view this Landscape Painting Demonstration in its entirety